The gap between the compacted board of the tree stump crusher can be adjusted by adjusting the nut (about 3-6 millimeters) on the hinge of the pressure plate to adjust the spacing between the pressure plate and the main shaft. In practice, it is adjusted to a high-quality gap of approximately 1 millimeter between the pressure plate and the spindle. If the gap is large, it may leak. If the gap is too small, the picking ingot will draw grooves on the pressure plate, which will damage the components.
By adjusting the relative position of the adjustment plate and the circular hole on the bracket, the spring tension of the pressure plate of the stump crusher can be adjusted. From the rotation of the adjustment plate until the spring just contacts the pressure plate, the front cotton picker continues to rotate and adjust to the 3 holes of the adjustment plate, and the rear cotton picker adjusts to the 4 holes, aligning with the holes fixed on the fixed plate. Bracket, insert flange screws. When adjusting the stump crusher, first adjust the pressure plate on the cotton picking head, and only tighten the pressure plate on the cotton picking head when necessary.
By adjusting the length of the boom on both sides of the front beam of the cotton picking machine, during the operation of the stump crusher, the front roller is 21 millimeters lower than the rear roller, which allows the picking spindle to come into contact with more cotton and discharges the residue from the cotton spinning machine. When the bottom of the cotton picking machine head goes out, it should be tilted and adjusted in the cotton warehouse.
